Sliding electric gates, sized to the opening, motorised to last.
Tracked and cantilever sliders for Perth driveways and commercial yards. We pick the motor by gate weight and duty cycle, not by the cheapest box on the shelf.
- 24 Month Warranty
- Perth Based
- Guil Runs Every Job
- Insured To $10 Million
Sliding gates, done right.
A sliding gate runs parallel to your fence line and is the right choice when the driveway is flat and you have side clearance to take the leaf. We install both tracked sliders and cantilever sliders, in single sizes from small residential to long commercial runs.
Configured to your property.
Different styles, features and automation configurations to suit your property.
Built to suit the site.
- Materials
- Steel or aluminium
- Length
- Up to 8m, longer if needed
- Finishes
- All Colorbond colours, matt or satin. Special colours at extra cost
- Kit includes
- Motor, 4m of rack and 2 remotes
- Fabrication
- Engineered and built by a local gate maker based in Bayswater
- Power
- Dedicated point, direct to the motor, low voltage up to 30m, or solar where there's no power
Bring us a photo, we’ll build it.
Designs range from basic slatted through to fully custom. Every gate is engineered and fabricated by a local gate maker based in Bayswater, so we are not limited to an off-the-shelf catalogue.
Steel or aluminium, in any Colorbond colour, matt or satin. Special colours are available at extra cost.
- Basic slatted
- Fully custom
- Steel
- Aluminium
- Special colours
Installed and serviced across the brands we fit.
FAAC, Centsys, Nice, BFT and DEA. We carry a number of basic parts on board, though not every part for every model.
Four steps, no surprises.
Plan it once, build it right, install it clean.
- Fabrication: usually 5 to 7 weeks
- Hours: Mon–Fri, 8am–4:30pm.
- Areas: Perth metro, mostly the western suburbs.
What our customers say
Customer experiences with Op’n Close Systems.
Kaye Smith, Google reviewMy automated sliding gate would not fully open today and I was unable to drive my car out. A friend recommended Gill and he was able to change his work schedule and come. He identified the problem immediately, replaced the part and then tested all the other areas of the motor to be sure they were fully functional. He even blew away all the cobwebs and dirt around the unit before replacing the housing. I would have no hesitation in recommending Gill. He was friendly, worked efficiently, and clearly is an expert in his field.
Kirstin Rintoul, Google reviewGuil replaced the motor on our electric swing gates – excellent service, prompt response and a really nice guy too. Highly recommend for any electric gate issues you might have 🤩
Real Perth jobs.
Across Perth
We work right across the Perth metro area, with most of our work in the western suburbs. If your suburb isn’t listed, give us a call.
- Dalkeith
- Floreat
- Peppermint Grove
- Mosman Park
- Nedlands
Common questions about our services.
-
You need clear run along the fence line, roughly the width of the gate plus a bit extra for the end post. We measure this on site before recommending a slider.
-
Sliding gates run parallel to the fence rather than swinging into the driveway, which is why they often suit sloped or tight blocks better than a swing gate. We check the site and recommend what suits.
-
Fabrication usually takes 5 to 7 weeks once the quote is accepted and the deposit is paid, and installation on site is usually done in 2 days.